YAGF Varilight LedFix is also known as The GlowFix to regulate loads of certain LEDs to Stop Afterglow When Turned Off

A GlowFix can improve performance in two ways:-

1. With certain combinations of lamps the addition of a GlowFix load regulator can improve the stability of the lamps at a lower brightness level, extending the dimming range when used with both V-Pro, V-Pro Eclique & V-Com dimmers.

2. Due to the extremely low current required to illuminate them, some LED lamps will remain illuminated at a low glow when remote control dimmers (such as Varilight's V-Pro Eclique dimmers)are switched off. This is because remote control dimmers draw a tiny current in standby mode so that they are ready to receive a signal from the handset. This tiny current may be sufficient to illuminate some LED lamps. The addition of just one GlowFix will solve this problem.

The Varilight GlowFix is super efficient, drawing less than 1 watt.

Fitting Instructions: Please see Instructions that are included with the YAGF. The GlowFix load regulator can be easily retrofitted by simply wiring it in parallel with any of the lamp fittings.

-Height (mm):24

-Width(mm): 25

-Length(mm): 66

-For Use With Dimmable LEDs like Megaman's Candle LED, E14's, G9's etc, to stop the glow when dimmer is turned off.

-Can improve the stability of LED lamps at lower brightness levels.
-Wiring Accessories PDF

- V-Pro Glowfix Instructions PDF