XDYR2VS.PD Varilight 2 Gang 10 Amp 2 Way & Off Retractive Switch Screwless Primed and Ready to Paint With Polished Brass Switches

Varilight 2 Gang, for 2 way circuits, 10 Amp Push To Make Switch also known as a Retractive, Momentary, Bell or Blind Switch, on a Single Plate, for use with all blinds, bells and applications where a momentary electric signal is required.

..................................................
VARILIGHT Switches have an industry-wide reputation for exceptional performance, long life and innovation at attractive prices.
..................................................
The Varilight switch, like all our products, is designed to meet the latest European Safety Legislation.
..................................................
It is important to select the correct switch for your application, so please read the following information carefully, if need be look at PDF manuals, and if you are still unsure, then contact us.
..................................................

Appearance, Function and Applications

What paint can I use? - You can use any paint, which will give you a variety of finishes.

How many coats will it typically take to finish them well? - Varilight recommend 3 coats for emulsion, which can be applied by brush or roller, and at least 1 coat for spray paint.

Will these conform to British Standards? - All our products conform to the BSEN Standards.

Can I remove the paint once painted - if so how? - You can't remove the paint unless you're confident in sanding it off with sandpaper or similar, but you can over-paint the plate if you decide to change your wall colour.

Do I still get a warranty once painted? - Warranty is for the working parts of the accessories, but not on the finish that has been applied.

What colour do they come unfinished? - They are a slightly creamy off white when they're unfinished.
..................................................
"These momentary switches resemble rocker switches, in that they are rectangular with a central fulcrum. The difference however, is that when you press the bottom of the rocker switch to turn on, you need to hold it to make contact. Then when the switch is released, it will spring back to the off position (in the centre). Similarily, when you press the top of the rocker switch to turn on, you need to hold it to make contact. Then when the switch is released, it will spring back to the off position (in the centre). It can be used where push-to-make switches are required, for example to trigger a relay or activate a motor that controls a blind, they can be used for all electric blinds, bells and applications where a momentary electric signal is required, please note, this switch is not waterproof. If this product is needed for external use please buy the following items IP66 Wall Box and if needed, a Spacer.
..................................................
The Push To Make are suitable for 1 way only circuits, i.e. where the circuit is controlled by 1 switch.
..................................................

Limitations

This switch is not waterproof. If this product is needed for external use please buy the following items IP66 Wall Box and if needed, a Spacer.
..................................................

Cleaning

This product can be easily cleaned with a soft dry micro-fibre cloth. Never apply masking tape or other similar tape to the product. Avoid the use of any cleaning chemicals and always use a Gasket on freshly plastered, painted or damp walls as the plates may tarnish. (Plaster can take up to 6 months to dry out). A Gasket can be made from the packaging the product comes in, or a plastic bag can be cut to stop the plate touching the plaster. Unfortunately, if these Instructions are not followed, and the plate is damaged, it will void the product warranty.
..................................................

Product Instructions & Manuals


- Momentary Switches PDF
- Wiring Accessories PDF
- Screwless Fitting PDF